NETGEAR ProSAFE SRX5308 - Page 59

Net Mode Configuration Commands
59
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net lan ipv4 default_vlan
This command configures the default VLAN for each port. After you have issued the net
lan ipv4 default_vlan command, you enter the net-config [lan-ipv4-defvlan] mode,
and then you can configure one keyword and associated parameter or associated keyword at
a time in the order that you prefer.
Command example:
SRX5308> net lan ipv4 default_vlan
net-config[lan-ipv4-defvlan]> port1 Default
net-config[lan-ipv4-defvlan]> port2 Default
net-config[lan-ipv4-defvlan]> port3 Management
net-config[lan-ipv4-defvlan]> port4 Sales
net-config[lan-ipv4-defvlan]> save
Related show command: show net lan ipv4 setup
net lan ipv4 advanced configure
This command configures advanced LAN settings such as the MAC address for VLANs and
ARP broadcast. After you have issued the net lan ipv4 advanced configure
command, you enter the net-config [lan-ipv4-adv] mode, and then you can configure one
Step 1 Format net lan ipv4 default_vlan
Mode net
Step 2 Format port1 <vlan name>
port2 <vlan name>
port3 <vlan name>
port4 <vlan name>
Mode net-config [lan-ipv4-defvlan]
Keyword Associated
Parameter to Type
Description
port1
vlan name
Specifies the default VLAN name. You need to specify the name
for each port individually.
port2
port3
port4