NETGEAR ProSAFE SRX5308 - Page 64

Net Mode Configuration Commands
64
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net lan ipv4 traffic_meter configure <ip address>
This command configures a LAN traffic meter profile for an IP address. When the traffic limit
has been reached, further traffic for that IP address is blocked. After you have issued the net
lan ipv4 traffic_meter configure command to specify the IP address, you enter
the net-config [lan-ipv4-traffic-meter] mode, and then you can configure one keyword and
associated parameter or associated keyword at a time in the order that you prefer.
Step 1 Format net lan ipv4 traffic_meter configure <ip address>
Mode net
Step 2 Format direction {Downloadonly | BothDirections}
limit <number>
counter {RestartCounter | SpecificTime {day_of_month <day>}
{time_hour <hour>} {time_meridian {AM | PM}} {time_minute
<minute>}}
send_email_report {Y | N}
send_email_alert {Y | N}
Mode net-config [lan-ipv4-traffic-meter]
Keyword Associated Keyword to Select or
Parameter to Type
Description
Traffic meter configuration
direction Downloadonly or BothDirections Specifies the type of traffic limit:
• Downloadonly. The traffic limit
applies to downloaded traffic only.
• BothDirections. The traffic limit
applies to both downloaded and
uploaded traffic.
limit number The limit for the traffic meter in MB.
Traffic counter configuration
counter SpecificTime or RestartCounter Specifies how the traffic counter is
restarted:
• SpecificTime. Restarts the traffic
counter on a specific day and time.
You need to set the
day_of_month, time_hour,
time_meridian, and
time_minute keywords and
associated parameters.
• RestartCounter. Restarts the traffic
counter after you have saved the
command.