NETGEAR ProSAFE SRX5308 - Page 78

Net Mode Configuration Commands
78
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
configure the IPv6 end address and the IPv6 prefix length for the IPv6 pool in the order that
you prefer.
Command example:
SRX5308> net dmz ipv6 pool configure 2001::1100
net-config[dmz-ipv6-pool]> ending_ip_address 2001::1120
net-config[dmz-ipv6-pool]> prefix_value 56
net-config[dmz-ipv6-pool]> save
Related show command: show net dmz ipv6 setup
net dmz pool ipv6 delete < ipv6 address>
This command deletes an IPv6 DHCP address pool for the DMZ by deleting the start address
of the pool.
Related show command: show net dmz ipv6 setup
net radvd configure dmz
This command configures the Router Advertisement Daemon (RADVD) process for the
link-local advertisements of IPv6 router addresses and prefixes in the DMZ. After you have
issued the net radvd configure dmz command, you enter the net-config [radvd-dmz]
Step 1 Format net dmz ipv6 pool configure <ipv6-address>
Mode net
Step 2 Format ending_ip_address <ipv6-address>
prefix_value <prefix length>
Mode net-config [dmz-ipv6-pool]
Keyword Associated
Parameter to Type
Description
ending_ip_address ipv6-address The end address of the IPv6 address pool.
prefix_value prefix length The prefix length for the IPv6 address pool.
Format net radvd pool dmz delete <ipv6-address>
Mode net