NETGEAR ProSAFE SRX5308 - Page 95

Net Mode Configuration Commands
95
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net routing static ipv4 delete_all
This command deletes all static IPv4 routes.
Related show command: show net routing static ipv4 setup
net routing dynamic configure
This command configures RIP and the associated MD5 key information. After you have
issued the net routing dynamic configure command, you enter the
net-config [dynamic-routing] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
Format net routing static ipv4 delete_all
Mode net
Step 1 Format net routing dynamic configure
Mode net
Step 2 Format authentication_enable {Y | N}
direction {None | In-only | Out-only | Both}
version {Disabled | Rip1 | Rip2B | Rip2M}
first_key authentication_id <authentication key>
first_key id_number <number>
first_key valid_from {day <day>}
first_key valid_from {month <month>}
first_key valid_from {year <year>}}
first_key valid_from {hour <hour> |
first_key valid_from {minute <minute>}
first_key valid_from {second <second>}
first_key valid_to {day <day>}
first_key valid_to {month <month>}
first_key valid_to {year <year>}}
first_key valid_to {hour <hour> |
f
irst_key valid_to {minute <minute>}
first_key valid_to {second <second>}