Section 3 Using PTs 3-3 Screen Display and Notification
3-7
NS Series Programming Manual
Using Command Buttons or Multifunction Objects to Close or Move Pop-up
Screens
Pop-up screens can be closed or moved by using Command Buttons.
Press a Command Button to which control Pop-up screen has been set under the button property set-
ting.
Close local pop-up screen: Closes the current pop-up screen if the Command Button is inside the
pop-up screen.
Close specified pop-up screen: Closes a specified pop-up screen.
Move local pop-up screen: Enables the current pop-up screen to be moved if the Command Button is
inside the pop-up screen.
Closing Pop-up Screens when Normal Screens Switched
Pop-up screens can be closed at the same time that the base screen used to open the pop-up screen
is switched to another screen.
Select Closes when base screen switches on the Size/Pop-up Tab Page found in the pop-up screen
property setting under PT – Screen/Sheet properties.
To Next Page
Loading...
