6-95
• Frequency Gain (Setting: 1)
Output Voltage Bias (Setting: 4)
DC Braking Current (Setting: 6)
Overtorque Detection Level (Setting: 7)
100%
–10 V 10 V0
Note 1. If
1 is set, the final gain will
be equal to the result of multiplication by the set value of H3-02.
Note 2. The setting 7 is only valid for overtorque detection 1.
• Acceleration/Deceleration Time Gain (Setting: 5)
Note The acceleration/deceleration time gain for 1 to 10 V is 10 V/input voltage (V) x 10%
• Stall Prevention Level (Setting: 8)
100%
–10 V 10 V0
• Output Frequency Lower Limit (Setting: 9)
Jump Frequency (Setting: A)
100%
–10 V 10 V0
Advanced Operation Chapter
6
To Next Page
Loading...
