Omron SYSDRIVE 3G3FV - Page 327

7-39
Setting
value
PageControl modeSetting
value
Page
Flux
vector
Open loop
Vector
V/f
w/PG
V/f
1B During baseblock 2 (OFF: During base block) OK OK OK OK ---
1C Motor 2 selected (ON: motor 2 selected) OK OK OK OK ---
1D Regenerating (ON: Regenerating) --- --- --- OK ---
1E Restart enabled (ON: Restart enabled) OK OK OK OK 6-107
1F Motor overload (OL1) pre-alarm (ON: 90% or
more of the detection level)
OK OK OK OK 6-92
20 Inverter overheat (OH) pre-alarm (ON:
Temperature is above L8-02)
OK OK OK OK 6-92
30 During torque limit (current limit) (ON: During
torque limit)
--- --- OK OK ---
31 During speed limit. (ON: During speed limit) --- --- --- OK ---
33 Zero-servo end (ON: Zero-servo) --- --- --- OK 6-93
37 During run 2 (ON: Frequency output, OFF: Base
block, DC braking, initialization, operation stop.
OK OK OK OK 6-92
H Analog Inputs: H3
Para
meter
Name
Description Setting
range
Default
setting
Chan-
ges
Control mode
Page
meter
No.
Display
name
range setting ges
during
opera-
tion
V/f
control
V/f
with
PG
Open
loop
vector
Flux
vector
H3-01
Signal
selection:
terminal 13
(Voltage)
0: 0 to +10 V
1: 0 to ± 10 V
0, 1 0 NO B B B B 5-5
T erm 13
Signal
H3-02
Gain: termi -
nal 13
Sets the frequency when 10 V
is input, as a percentage of the
if
0.0 to
1000.0
100.0 OK B B B B 5-7
T erminal 13
Gain
,g
maximum frequency .
H3-03
Bias: termi -
nal 13
Sets the frequency when 0 V is
input, as a percentage of the
if
–100.0
to
100 0
0.0 OK B B B B 5-7
T erminal 13
Bias
,g
maximum frequency . +100.0
H3-04
Multi-func-
tion analog
input signal
selection:
terminal 16
0: 0 to +10 V
1: 0 to ± 10 V
0, 1 0 NO B B B B 5-7
T erm 16
Signal
H3-05
Selection:
T
erminal 16
Select from the functions listed
on the following table. Refer to
693
0 to 1F 1F NO B B B B 5-7,
6-93
T erminal 16
Sel
g
page 6-93.
H3-06
Gain: termi -
nal 16
Sets the input gain (level) when
terminal 16 is 10 V .
Th t t i th f ll i
0.0 to
1000.0
100.0 OK B B B B 5-8
T erminal 16
Gain
The contents in the following
table are taken as 100%.
H3-07
Bias: termi -
nal 16
Sets the input gain (level) when
terminal 16 is 0 V .
Th t t i th f ll i
–100.0
to
100 0
0.0 OK B B B B 5-8
T erminal 16
Bias
The contents in the following
table are taken as 100%.
+100.0
Parameter Lists Chapter 7