7-41
D Description of Multi-function Analog Input: Terminal 16
Function Contents Control mode
0 Auxiliary frequency reference Maximum frequency OK OK OK OK
1 Frequency gain Frequency reference command
value (voltage.)
OK OK OK OK
2 Frequency bias Maximum frequency (H0-03 +) OK OK OK OK
4 Voltage bias Motor rated voltage (E1-05) OK OK --- ---
5 Accel/decel change Set acceleration and
deceleration times (C1-01 to
C1-08)
OK OK OK OK
6 DC injection braking current Inverter rated output current OK OK OK ---
7 Overtorque detection level Motor rated torque OK OK OK OK
8 Stall prevention level during run Inverter rated output current OK OK --- ---
9 Frequency reference lower limit
level
Maximum frequency OK OK OK OK
A Jump frequency Maximum frequency OK OK OK OK
B PID feedback Maximum frequency OK OK OK OK
C PID target value Maximum frequency OK OK OK OK
D Frequency bias 2 (rotates in
reverse with negative values)
Maximum frequency (H0-03 +) OK OK OK OK
10 Forward side torque limit Rated torque --- --- OK OK
11 Reverse side torque limit Rated torque --- --- OK OK
12 Regeneration side torque limit Rated torque --- --- OK OK
13 Torque reference/torque limit at
speed control
Rated torque --- --- --- OK
14 Torque compensation (bias) Rated torque --- --- --- OK
15 Forward/reverse side torque limit Rated torque --- --- OK OK
1F Not used (terminal 14: frequency
reference)
--- OK OK OK OK
Parameter Lists Chapter
7
To Next Page
Loading...
