Omron SYSDRIVE 3G3FV - Page 330

7-42
H Analog Outputs: H4
Para
meter
Name
Description Setting
range
Default
setting
Chan-
ges
Control mode
Page
meter
No.
Display
name
range setting ges
during
opera-
tion
V/f
control
V/f
with
PG
Open
loop
vector
Flux
vector
H4-01
Multi-func-
tion analog
output 1
selection:
terminal 21
Sets the number of the monitor
item to be output (U1-
 ) from
terminal 21.
Note: Settings 4, 10, 1 1, 12, 13,
14, 25, 28, 34, and 35
1 to 38 2 NO B B B B 6-96
T erminal 21
Sel
14
,
25
,
28
,
34
,
and
35
cannot be set and 29 to
31 are not used.
H4-02
Gain
terminal 21
Sets the multi-function analog
output 1 voltage level gain.
Sets whether the monitor item
0.00 to
2.50
1.00 OK B B B B 6-97
T erminal 21
Gain
Sets whether the monitor item
output will be output in multiples
of 10 V .
H4-03
Bias
terminal 21
Sets the multi-function analog
output 1 voltage level bias.
Sets out
p
ut characteristic
–10.0
to
+10 0
0.0 OK B B B B 6-97
T erminal 21
Bias
Sets output characteristic
up/down parallel movement as
a percentage of 10 V .
+10.0
H4-04
Multi-func-
tion analog
output 2
selection:
terminal 23
Sets the number of the monitor
item to be output (U1-
 ) from
terminal 23.
Note: Settings 4, 10, 1 1, 12, 13,
14, 25, 28, 34, and 35
1 to 38 3 NO B B B B 6-96
T erminal 23
Sel
14
,
25
,
28
,
34
,
and
35
cannot be set and 29 to
31 are not used.
H4-05
Gain
terminal 23
Sets the multi-function analog
output 2 voltage level gain.
Sets whether the monitor item
0.00 to
2.50
0.50 OK B B B B 6-97
T erminal 23
Gain
Sets whether the monitor item
output will be output in multiples
of 10 V .
H4-06
Bias
terminal 23
Sets the multi-function analog
output 2 voltage level bias.
Sets out
p
ut characteristic
–10.0
to
+10 0
0.0 OK B B B B 6-97
T erminal 23
Bias
Sets output characteristic
up/down parallel movement as
a percentage of 10 V .
+10.0
H4-07
Analog
output
signal level
selection
Sets the signal output level for
multi-function outputs 1 and 2
(terminals 21, 23.)
0: 0 to +10 V output
1: 0 to ± 10 V output
0, 1 0 NO B B B B 6-97
AO Level
Select
1: 0
to
± 10
V
out ut
Note: The optional Analog Mon -
itor Card may also be
used with this setting.
Parameter Lists Chapter 7