3-6
The following diagram shows this procedure in flowchart format.
** Main Menu **
Operation
** Main Menu **
Initialize
Access Level
Quick Start
A1-01= 2 ***
Quick-Start
A1-01= 3
Basic Level
Entry Accepted
Access Level
Basic Level
Select Language
English
S Setting Parameters in Each Access Level
• The displays in program mode differ
for each access level. (There is no dif
ference in other modes.)
• This
section provides the procedure to change the acceleration time to 20 s in each access level. The
acceleration time (C1-01) is a parameter in program mode.
• If the new parameter setting is not written to the Unit (by pressing the Enter Key) within one minute
after
starting the procedure, the display will automatically revert to the original parameter setting. In
this case, the procedure must be started again.
Preparing for Operation Chapter
3
To Next Page
Loading...
