Oracle X6-2 - Servicing the Power, FIM, Disk Backplane Data, and DVD Cables

Servicing the Power, FIM, Disk Backplane Data, and DVD Cables
Servicing FRUs 181
See “Install a Fan Module” on page 79.
6.
Return the server to operation.
a.
Install the server top cover.
See “Install the Server Top Cover” on page 188.
b.
Close the server fan door.
c.
Return the server to the normal rack position.
See “Return the Server to the Normal Rack Position” on page 191.
d.
Power on the server.
See “Power On the Server” on page 194.
Verify that the Power/OK status indicator is steady on.
Related Information
■
“Install the NVMe Cables” on page 180
Servicing the Power, FIM, Disk Backplane Data, and DVD
Cables
Caution - The Power, front indicator module, disk backplane data, and DVD cables should be
serviced only by authorized Oracle Services personnel.
Caution - The system supplies power to the cables even when the server is powered off.
To avoid personal injury or damage to the server, you must disconnect power cords before
servicing the cables.
This section covers the following procedures:
■
“Remove the Internal HBA SAS Cable Assembly” on page 173
■
“Install the Internal HBA SAS Cable Assembly” on page 176
Related Information
■
“Extend the Server to the Maintenance Position” on page 56