Oracle X6-2 - System Chassis Components

Monitoring System Components
Monitoring Components and Identifying SNMP Messages 253
■
“System Board Components” on page 259
■
“System Firmware Components” on page 261
■
“Hard Disk Drive Components” on page 262
System Chassis Components
The following table lists the system chassis components.
Component Name
(Oracle ILOM CLI
Targets)
IPMI
Type
Description Values (if applicable)
/SYS FRU Product information only
/SYS/UUID FRU Unique system ID Derived from host MAC address. Used for PXE
boot and licensing.
/SYS/ACPI State
sensor
Advanced Configuration
and Power Interface
(hidden)
01h-ACPI_ON_WORKING
20h-ACPI_SOFT_OFF
/SYS/VPS Threshold
sensor
Virtual power sensor Watts
/SYS/VPS_CPUS Threshold
sensor
Virtual power sensor
(CPUs)
Watts
/SYS/VPS_MEMORY Threshold
sensor
Virtual power sensor
(Memory)
Watts
/SYS/VPS_FANS Threshold
sensor
Virtual power sensor
(Fans)
Watts
/SYS/INTSW Discrete
sensor
Chassis intrusion switch 01h-Deasserted
02h-Asserted
/SYS/T_AMB Threshold
sensor
Ambient temperature
on system motherboard,
located on the front
indicator module (FIM).
Degrees Celsius
/SYS/TEMP_FAULT Indicator Temperature Fault LED Color: Amber
Location: Front panel
Off: Normal
On: Chassis overtemp fault
/SYS/OK Indicator Power/OK LED Color: Green
Location: Front panel
Off: Power is off or the Oracle ILOM boot is not
complete.