Oracle X6-2 - Removing the Nvme Cables

Removing the NVMe Cables
178 Oracle Server X6-2 Service Manual • June 2016
Related Information
■
“Extend the Server to the Maintenance Position” on page 56
■
“Take Antistatic Measures” on page 59
■
“Remove the Server Top Cover” on page 60
Removing the NVMe Cables
Caution - The Oracle PCIe NVMe switch card cables should be removed only by an Oracle
qualified service technician.
1.
Prepare the server for service.
a.
Power off the server and disconnect the power cords from the power
supplies.
See “Powering Down the Server” on page 51.
b.
Extend the server to the maintenance position.
See “Extend the Server to the Maintenance Position” on page 56.
c.
Attach an antistatic wrist strap to your wrist, and then to a metal area on the
chassis.
See “Take Antistatic Measures” on page 59.
d.
Remove the server top cover.
See “Remove the Server Top Cover” on page 60.
2.
Remove the two middle server fan modules.
See “Remove a Fan Module” on page 76.