Oracle X6-2 - Related Information; Required Tools; Preparing the Server for Component Replacement

Required Tools
50 Oracle Server X6-2 Service Manual • June 2016
Note - Only one of the quorum members can be replaced at a time. Automated updates can only
be completed when two of the three quorum members contain matching key identity properties.
Related Information
■
“Servicing Power Supplies (CRU)” on page 80
■
“Servicing the Disk Backplane (FRU)” on page 150
■
“Servicing the Motherboard (FRU)” on page 162
Required Tools
The server can be serviced with the following tools:
■
Antistatic wrist strap
■
Antistatic mat
■
No. 2 Phillips screwdriver
Related Information
■
“Preparing for Service” on page 47
■
“Servicing CRUs That Do Not Require Server Power-Off” on page 63
■
“Servicing CRUs That Require Server Power-Off” on page 85
■
“Servicing FRUs” on page 119
Preparing the Server for Component Replacement
Before you can remove and install components that are inside the server, you must perform the
procedures in the following tasks:
Note - When replacing the storage drives or power supplies, not all of these procedures are
necessary. See the replacement tasks for those components for more information.
■
“Powering Down the Server” on page 51
■
“Disconnect Cables From the Server” on page 56
■
“Extend the Server to the Maintenance Position” on page 56
■
“Remove the Server From the Rack” on page 58