BIOS Advanced Menu Selections
BIOS Setup Utility Menu Options 237
Setup Options Options Defaults Description
option. If disabled, the OS
will not show TPM. Reset
of the platform is required.
TPM State Disabled/Enabled Disabled Displays whether TPM
Support is enabled.
Note - This option is
available only if TPM
Support is set to enabled.
Pending Operation None/Enable Take
Ownership/Disable Take
Ownership/TPM Clear
None Used to schedule an
operation for the security
device.
Note - Your computer will
reboot during restart in
order to change the state of
a security device.
Current Status
Information
If TPM Support is
disabled, Current Status
Information displays
SUPPORT Turned OFF.”
TPM Enabled Status Disabled/Enabled Disabled Use this option to provide
the current capability state
of the security device.
Note - This option is
available only if TPM
Support is set to enabled.
TPM Active Status Deactivated/Activated Deactivated Use this option to provide
the current capability state
of the security device.
Note - This option is
available only if TPM
Support is set to enabled.
TPM Owner Status Owned/Unowned Unowned Use this option to provide
the current ownership
state.
Note - This option is
available only if TPM
Support is set to enabled.
BIOS Advanced Menu Network Stack Options
The following table lists the BIOS Advanced Menu Network Stack options.
TABLE 34
BIOS Advanced Menu Network Stack Options
Setup Options Options Defaults Description
Network Stack Disabled/Enabled Enabled Enable or disable the UEFI
network stack.
Ipv4 PXE Support Disabled/Enabled Enabled Enable or disable IPv4
PXE Boot support. If
To Next Page
Loading...
