Oracle X6-2 - Reconnect Data Cables and Power Cords

Reconnect Data Cables and Power Cords
Returning the Server to Operation 193
3.
If the cables are disconnected from the rear of the server, that is, you
disconnected the cables because you removed the server completely out of the
rack, reconnect the cables.
■
For instructions on reconnecting cables to the rear of the server, see “Reconnect Data Cables
and Power Cords” on page 193.
■
For detailed information on connecting cables to the rear of the server, refer to “Rear Cable
Connections and Ports” in Oracle Server X6-2 Installation Guide.
Related Information
■
“Reconnect Data Cables and Power Cords” on page 193
Reconnect Data Cables and Power Cords
1.
Reconnect the data cables to the rear of the server, as required.
If the cable management arm (CMA) is in the way, extend the server approximately 13 cm (5
inches) out of the front of the rack.
2.
Reconnect the power cables to the power supplies and secure them with the
reclosable straps as shown in the following figure.