Oracle X6-2 - Install the DVD Drive; Servicing the Front Indicator Module (FRU)

Install the DVD Drive
158 Oracle Server X6-2 Service Manual • June 2016
7.
Place the DVD drive on an antistatic mat.
Related Information
■
“Install the DVD Drive” on page 158
Install the DVD Drive
1.
Push the DVD drive into the chassis until the release tab on the rear of the DVD
drive engages the chassis with an audible click (see Figure 30 [4]).
2.
Reconnect the DVD drive cable [2].
3.
Return the server to operation.
a.
Install the server top cover.
See “Install the Server Top Cover” on page 188.
b.
Close the fan door.
c.
Return the server to the normal rack position.
See “Return the Server to the Normal Rack Position” on page 191.
d.
Reconnect the power cords to the server power supplies and reconnect the
data cables.
See “Reconnect Data Cables and Power Cords” on page 193.
e.
Power on the server.
See “Power On the Server” on page 194.
Verify that the Power/OK status indicator is steady on.
Related Information
■
“Remove the DVD Drive” on page 156
Servicing the Front Indicator Module (FRU)
Caution - The front indicator module should be serviced only by authorized Oracle Services
personnel.