Oracle X6-2 - Servicing the DVD Drive (FRU); Remove the DVD Drive

Servicing the DVD Drive (FRU)
156 Oracle Server X6-2 Service Manual • June 2016
Servicing the DVD Drive (FRU)
Note - The DVD drive is optional.
The DVD drive is accessible from the front panel of the system.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the components to fail. To avoid
damage, ensure that you follow antistatic practices as described in “Take Antistatic
Measures” on page 59.
Caution - Ensure that all power is removed from the server before removing or installing the
DVD drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
This section covers the following procedures:
■
“Remove the DVD Drive” on page 156.
■
“Install the DVD Drive” on page 158.
Related Information
■
“Disconnect Cables From the Server” on page 56
■
“Extend the Server to the Maintenance Position” on page 56
■
“Open the Server Fan Door” on page 59
Remove the DVD Drive
1.
Remove any media from the DVD drive.
2.
Prepare the server for service.
a.
Power off the server and disconnect the power cords from the power
supplies.
See “Powering Down the Server” on page 51.
b.
Extend the server to the maintenance position.
See “Extend the Server to the Maintenance Position” on page 56.
c.
Attach an antistatic wrist strap to your wrist and then to a metal area on the
chassis.