Oracle X6-2 - Page 242

BIOS Advanced Menu Selections
242 Oracle Server X6-2 Service Manual • June 2016
Setup Options Options Defaults Description
iSCSI target using the IPv4
stack. If this fails, then
the iSCSI driver attempt
to connect using the IPv6
stack.
Connection Retry Count 0 to 16 0 The count range is 0 to
16. If set to 0, there are no
retries.
Connection Establishing
Timeout
NA 1,000 The timeout value
in milliseconds. The
minimum value is 100
milliseconds and the
maximum is 20 seconds.
Configure ISID Derived from the MAC
address
The default value is
derived from the Mac
Address
The OUI-format ISID is
6 bytes. The default value
is derived from the MAC
address. Only the last 3
bytes are configurable.
Example: Update
0ABBCCDDEEFF to
0ABBCCF07901 by
inputting F07901
Enable DHCP Disabled/Enabled Disabled Enable or disable DHCP
Initiator IP Address NA 0.0.0.0 Use to set initiator IP
address in dotted-decimal
notation.
Initiator Subnet Mask NA 0.0.0.0 Use to set initiator subnet
mask IP address in dotted-
decimal notation.
Gateway NA 0.0.0.0 Use to set initiator gateway
IP address in dotted-
decimal notation.
Target Name NA NA The worldwide unique
name of the target. Only
IQN format is accepted.
Target IP address 0.0.0.0 None Use to set target IP address
in dotted-decimal notation.
Target Port  3260 Use to change target port
number.
Boot LUN  0 Use to set the hexadecimal
representation of the
boot logical unit number
(LUN).
Example: 4752-3A4F-
6b7e-2F99
Authentication Type CHAP/None CHAP Define the Challenge-
Handshake Authentication
Protocol (CHAP).
Available settings are