Technical manual Planmeca ProOne 31
Chapter B: SETTINGS
1 GENERAL ABOUT SETTINGS
Some of the settings can be used to alter the operation of the X-ray unit. Never use
functions that you are not familiar with.
The Planmeca ProOne X-ray unit has a number of additional functions for special
requirements. The additional functions can be entered by touching the service spanner
icon on the main display. The main display is the display that is shown when the X-ray unit
is switched on.
The functions are divided into three groups: User settings (
User
tab), Program settings
(Program
tab) and Technical settings (
Technical
tab). The
User
and
Program
tabs can be
entered without a password. The information and functions behind the
Technical
tab are
intended for service personnel only. Access to the these settings requires a password.
The password has to be entered each time the X-ray unit is switched on.
To return to the main display, touch the green check mark button in the bottom right corner
of the display.
Service spanner
Function tabs
To Next Page
Loading...
