Chapter E: CALIBRATIONS 1 ADJUSTING AND CALIBRATING X-RAY BEAM
Technical manual Planmeca ProOne 111
1.9 Step 6: Calibrating the sensor
Refer to the Planmeca Device Tool manual, publication number 10031558.
1.10 Step 7: Taking beam check exposure
Refer to the Planmeca Device Tool manual, publication number 10031558.
1.11 Step 8: Taking a ball phantom exposure
Refer to the Planmeca Device Tool manual, publication number 10031558.
In case of test failure, see the ball phantom and patient support table adjustment
instructions in this manual.
Remove the ball phantom from the patient support table. You have now successfully
completed the entire beam adjustment and calibration procedure.
To Next Page
Loading...
