Technical manual Planmeca ProOne 5
Chapter A: GENERAL & TECHNICAL
DATA
1 INTENDED USE
The Planmeca ProOne X-ray unit produces digital X-ray images for the diagnosis of
dentomaxillofacial anatomy. The X-ray unit may be used by health care professionals only.
2 SOFTWARE VERSION
The software version of the X-ray unit determines what settings and functions are
available on the X-ray unit.
The X-ray unit’s software version is shown briefly on the control panel when the X-ray unit
is switched on. This manual is valid for software version 1.9.0.0.r or later. This software
version is compatible with Romexis software version 4.4.1.R or later.
If the settings or functions described in this manual are not available on the X-ray unit,
update the X-ray unit software to the latest version as described in section 4.5 "Technical:
Update software (T3500)" on page 68.
3 ASSOCIATED DOCUMENTATION
The X-ray unit is supplied with the following manuals:
• User’s Manual, Original English publication: 10016256
• Installation Quick Guide, Original English publication: 10040577
• Installation Manual, Original English publication: 10016257
• Technical Manual, Original English publication: 10016258
• Planmeca Device Tool Manual, Original English publication: 10031558
These manuals are intended to be used in conjunction with the documentation for the
Planmeca Romexis program. The program package contains the following manuals:
• User’s Manual, Original English publication: 10014593
• Technical Manual, Original English publication: 10037884
The User’s Manuals are available on Planmeca’s website.
• For X-ray units, select Material bank > Manuals > Imaging.
• For software products, select Material bank > Manuals > Software.
To Next Page
Loading...
