Planmeca ProOne - Returning C-arm to Patient Entry Position; Operating Temple Supports; Adjusting the Layer Light Position

2 USER SETTINGS Chapter B: SETTINGS
40 Planmeca ProOne Technical manual
Gateway: This field shows the gateway IP (Internet Protocol) address. The value may
be changed by a service technician/local administrator only.
To change the gateway IP address, touch the
Gateway field and enter the new
address on the number keyboard that appears. Save the new gateway IP address by
touching the green check mark button, or exit the number display by touching the red
cross button.
NOTE: The IP, Netmask and Gateway addresses have to be static and specified by
the service technician/local administrator to be used only for this configuration.
Exit the
Network settings (U1400) display by touching the green check mark button in the
bottom right corner of the display.