Chapter C: ERROR MESSAGES 1 ERROR MESSAGES
Technical manual Planmeca ProOne 77
E02-012 Lift motor Limit sensors The lift motor limit sensors (upper and
lower) are either defective or disconnected.
Check the lift motor limit sensors.
E02-013 Short circuit There is a short circuit in the lift motor.
Check the lift motor cable.
E02-015 Collimator
movement
The collimator is not functioning correctly.
Check that the mechanism is not stuck. The
collimator may need to be serviced.
E02-016 Temple support
motor
Limit sensors The temple support motor limit sensor
(open or close) is either defective or
disconnected.
Check the temple support motor limit
sensor.
Code Explanation Comments
To Next Page
Loading...
