Administrator’s Guide for the Polycom RealPresence Group Series Managing the System Remotely
Polycom, Inc. 143
You can configure the system to use the following directory servers when the system is automatically
provisioned by a Polycom CMA or Polycom RealPresence Resource Manager system.
To configure the Polycom GDS directory server:
1 In the web interface, go to Admin Settings > Servers > Directory Servers and select the Polycom
GDS Service Type.
2 Configure these settings on the Directory Servers page.
Directory Servers
Supported
Authentication
Protocols
Global Directory
Groups Entry Calling Information
Polycom GDS Proprietary Not Supported Might include:
• H.323 IP address (raw IPv4 address, DNS
name, or H.323 extension)
• ISDN number
LDAP with H.350 or
Active Directory
Any of the
following:
• NTLM v2
only
• Basic
• Anonymous
Not Supported Might include:
• H.323 IP address (raw IPv4 address, DNS
name, H.323 dialed digits, H.323 ID, or
H.323 extension)
• SIP address (SIP URI)
• ISDN number
• Phone number*
Microsoft Lync Server
2010 and 2013
NTLM v2 only Contact groups but
not distribution
lists
Might include:
• SIP address (SIP URI)
* To successfully call a phone number from the LDAP directory, the phone number must be stored in one of the
following formats:
• +Country Code.Area Code.Number
• +Country Code.(National Direct Dial Prefix).Area Code.Number
Directory Servers
Supported
Authentication
Protocol
Global Directory
Groups
Entry Calling Information
LDAP by a Polycom
CMA system
NTLM v2 only Pre-defined groups
from the LDAP
directory are shown in
Polycom
RealPresence Group
system’s directory
Might include:
• H.323 dialed digits, H.323 ID, or H.323
extension
• Phone number*
Microsoft Lync
Server 2010 and
2013
NTLM v2 only Contact groups but not
distribution lists
Might include:
• SIP address (SIP URI)
* To successfully call a phone number from the LDAP directory, the phone number must be stored in one of the
following formats:
• +Country Code.Area Code.Number
• +Country Code.(National Direct Dial Prefix).Area Code.Number
To Next Page
Loading...
