Administrator’s Guide for the Polycom RealPresence Group Series Managing the System Remotely
Polycom, Inc. 144
To configure the LDAP directory server:
1 In the web interface, go to Admin Settings > Servers > Directory Servers and select the LDAP
Server Type.
2 Configure these settings on the Directory Servers page.
To configure the Microsoft Lync Server 2010 or 2013 directory settings:
1 In the web interface, go to Admin Settings > Network > IP > SIP Settings.
2 Configure the SIP settings as described in Configure SIP Settings for Integration with Microsoft
Servers.
3 In the web interface, go to Admin Settings > Servers > Directory Servers and select the
Microsoft Lync Server 2010 Service Type.
4 Configure these settings on the Directory Servers page.
Setting Description
Server Address Specifies the IP address or DNS address of the Global Directory Server. You can enter up to
five addresses.
Password Lets you enter the global directory password, if one exists.
LDAP Setting Description
Server Address Specifies the address of the LDAP directory server. With Automatic Provisioning, this setting
is configured by the server and appears as read only.
Server Port Specifies the port used to connect to the LDAP server. With Automatic Provisioning, this
setting is configured by the server and appears as read only.
Base DN
(Distinguished
Name)
Specifies the top level of the LDAP directory where searches will begin. With Automatic
Provisioning, this setting is configured by the server and appears as read only.
Multitiered
Directory
Default Group
DN
Specifies the top level group of the LDAP directory required to access the hierarchical
structure. With Automatic Provisioning, this setting is configured by the server and appears as
read only.
Authentication
Type
Specifies the protocol used for authentication with the LDAP server: NTLM, BASIC, or
Anonymous.
Use SSL
(Secure Socket
Layer)
Enables SSL for securing data flow to and from the LDAP server.
Domain Name Specifies the domain name for authentication with the LDAP server.
User Name Specifies the user name for authentication with LDAP server.
Password Specifies the password for authentication with the LDAP server.
To Next Page
Loading...
Need help?
General
