Cylinder Head and Valves
02
020
41
RG,RG34710,92 –19–28NOV00–2/6
RG8152 –UN–05DEC97
Installing Injector Sleeve Packing
A—Square Packing
Install Unit Injector Sleeve
1. Grease square packing (A) and sleeve bore in head
with JDT405 High Temperature Grease and install in
packing seat area of injector sleeve bore. Take care
that packing is not twisted during installation.
RG,RG34710,92 –19–28NOV00–3/6
RG12417 –UN–04SEP02
Installing Injector Sleeve
RG12415 –UN–04SEP02
A—Injector Sleeve
B—Old Injector Sleeve
C—New Injector Sleeve
IMPORTANT: Old injector sleeve (B) with one O-ring
MUST be replaced with new injector
sleeve (C) with two O-rings.
IMPORTANT: DO NOT use engine oil or any
petroleum based product as a lubricant
for the injector sleeve o-rings. A
chemical reaction will occur, leading to
o-ring failure. Instead use a soap based
solution to lubricate the packing.
2. Lubricate injector sleeve (A) with clean engine oil and
push into sleeve bore with minimal pressure until tightly
seated.
CTM100 (06APR04)
02-020-41
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=113
Continued on next page
To Next Page
Loading...