Starting and Charging Systems
02
100
2
DPSG,OUO1004,1006 –19–13AUG99–1/1
Remove and Install Starter Motor (OEM
Engines)
RG10285 –UN–20AUG99
Starter Motor
A—Starter Solenoid
NOTE: For test and repair of starter motor, refer to CTM
77.
1. Disconnect battery ground (-) cable.
2. Disconnect all cables and wires from starter solenoid
(A) (shown disconnected).
3. Remove starter motor using JDE80 Starter Wrench.
4. Install starter motor in reverse order.
5. Torque motor mounting hardware to the following
specifications.
Specification
Starter Motor Mounting
Hardware—Torque 125 N•m (92 lb-ft)........................................................
CTM100 (06APR04)
02-100-2
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=330
To Next Page
Loading...