PowerTech 6105HF - Install Oil Cooler;Oil Filter Valve Housing Assembly or Oil Cooler Cover;Valve Housing Assembly

Lubrication System
02
060
8
RG,RG34710,212 –19–12AUG99–3/3
11. If removed, apply LOCTITE

242 Thread Lock and
Sealer to oil pressure sending unit. Install sending
unit and tighten securely.
LOCTITE is a registered trademark of Loctite Corp.
RG,RG34710,213 –19–24SEP02–1/2
Install Oil Cooler/Oil Filter Valve Housing
Assembly or Oil Cooler Cover/Valve Housing
Assembly
RG8249A –UN–06DEC97
Installing Oil Cooler and Housing Assembly
RG8248B –UN–06DEC97
Oil Cooler and Housing Assembly Installed
A—Oil Cooler and Housing Assembly
B—Hex Socket Head Cap Screws
NOTE: Standard filter/valve housing assembly shown.
Procedure for remote filter applications is similar.
1. Remove all gasket material from cylinder block, oil
cooler housing, and oil filter/valve housing. All sealing
surfaces must be clean and free of oil.
NOTE: Use guide pins as an assembly aid if desired.
2. Install oil cooler and housing assembly (A) using a new
gasket. Position oil cooler housing-to-coolant pump
hose on coolant pump outlet elbow.
3. Install two hex socket head cap screws (B) and tighten
to specifications.
Specification
Oil Cooler Housing-to-Block Cap
Screws—Torque 68 N•m (50 lb-ft)..............................................................
Continued on next page
CTM100 (06APR04) 02-060-8 P OWER T ECH 10.5 L & 12.5 L Diesel Engines
040604
PN=276