Lubrication System
02
060
9
RG,RG34710,213 –19–24SEP02–2/2
RG8247 –UN–21MAY98
Install Filter and Valve Housing
RG8815 –UN–20MAY98
Oil Filter Housing Torque Sequence
4. Install oil filter/valve housing (or oil cooler cover/valve
housing on remote applications) using a new gasket.
Tighten cap screws to specifications using sequence
shown in lower illustration.
Specification
Oil Filter/Valve Housing or Oil
Cooler Cover/Valve Housing
1
—
Torque 68 N•m (50 lb-ft).............................................................................
5. Retighten cap screws to specification using same
sequence.
Specification
Oil Cooler Housing-to-Block Cap
Screws—Retorque 68 N•m (50 lb-ft)...........................................................
6. Tighten coolant pump-to-oil cooler housing hose
clamps securely.
7. Coat oil filter gasket with clean engine oil. Install filter
to housing until gasket contacts base, then tighten an
additional 1/2—3/4 turn.
8. If equipped with a remote filter: Connect hose or line
ends to oil cooler cover/valve housing and tighten hose
or line ends to specification.
Specification
Remote Filter Inlet Hose or
Line—Torque 190 N•m (140 lb-ft)...............................................................
Remote Filter Outlet Hose or
Line—Torque 142 N•m (105 lb-ft)...............................................................
9. Install turbocharger oil inlet line onto housing adapter
and tighten to specifications.
Specification
Turbocharger Oil Inlet Line-to-Oil
Cooler Housing—Torque 35 N•m (26 lb-ft).................................................
1
Torque sequence and specification also applies to oil cooler cover/valve
housing on remote filter applications.
CTM100 (06APR04)
02-060-9
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=277
To Next Page
Loading...