Fuels, Lubricants and Coolant
01
002
13
RG,01,DT7035 –19–14NOV00–1/2
Replenishing Supplemental Coolant Additives (SCAs) Between Coolant Changes
RG6261 –UN–08DEC97
Radiator Coolant Check
RG6262 –UN–05DEC97
JT07298 Refractometer
IMPORTANT: Do not add supplemental coolant
additives when the cooling system is
drained and refilled with John Deere
ANTIFREEZE/SUMMER COOLANT or
John Deere COOL-GARD

.
NOTE: If a system is to be filled with coolant that does
not contain SCAs, the coolant must be
precharged. Determine the total system
capacity and premix with 3% John Deere
Coolant Conditioner.
Through time and use, the concentration of coolant
additives is gradually depleted during engine operation.
Periodic replenishment of inhibitors is required, even
when John Deere ANTIFREEZE/SUMMER COOLANT
is used. The cooling system must be recharged with
additional supplemental coolant additives available in
the form of liquid coolant conditioner.
Maintaining the correct coolant conditioner
concentration (SCAs) and freeze point is essential in
your cooling system to protect against rust, liner pitting
and corrosion, and freeze-ups due to incorrect coolant
dilution.
John Deere LIQUID COOLANT CONDITIONER is
recommended as a supplemental coolant additive
in John Deere engines.
DO NOT mix one brand of SCA with a different
brand.
Test the coolant solution at 600 hours or 12 months of
operation using either John Deere coolant test strips or
a COOLSCAN

analysis. If a COOLSCAN

analysis is
not available, recharge system per instructions printed
on label of John Deere Liquid Coolant Conditioner.
COOL-GARD is a registered trademark of Deere & Company
COOLSCAN is a registered trademark of Deere & Company.
Continued on next page
CTM100 (06APR04)
01-002-13
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=43
To Next Page
Loading...
General