PowerTech 6105HF - Remove Rear Crankshaft Oil Seal and Housing Assembly

Crankshaft, Main Bearings, and Flywheel
02
040
13
RG,RG34710,161 –19–13AUG99–1/4
Remove Rear Crankshaft Oil Seal and
Housing Assembly
RG8291 –UN–06DEC97
Removing Rear Oil Seal and Housing
A—Cap Screws
To remove rear crankshaft oil seal, the seal housing
MUST BE removed also.
1. Remove engine oil pan, if not previously removed.
(See REMOVE ENGINE OIL PAN, in Group 060.)
Remove flywheel, if not previously removed. (See
REMOVE FLYWHEEL earlier in this group.)
2. Remove eight cap screws (A) securing rear seal to
housing.
RG,RG34710,161 –19–13AUG99–2/4
RG8293 –UN–21MAY98
Separating Rear Seal From Housing
3. Separate seal from housing using a small flat
screwdriver and heel-type prybar as shown.
Continued on next page
CTM100 (06APR04) 02-040-13 P OWER T ECH 10.5 L & 12.5 L Diesel Engines
040604
PN=209