PowerTech 6105HF - Install Engine Oil Pan

Lubrication System
02
060
15
RG,RG34710,219 –19–24SEP02–1/2
Install Engine Oil Pan
RG10273A –UN–03APR02RG10274 –UN–06AUG99
Sealant Applications—Rear Rail
A—Front T-Joints
C—Rear T-Joints
NOTE: When installing the oil pan gasket and pan,
ensure that the oil pan bolts are installed loosely
(leave approximately 1/4 inch gap between the
pan and block pan rail).This will allow the gasket
to center itself to the bolt and block pattern. Once
the bolts are installed, follow the torque sequence
defined later in this group.
All oil pan and cylinder block gasket sealing surfaces
(including timing gear cover and rear seal housing) MUST
BE free of gasket material and oil. Surface must be dry.
1. Apply LOCTITE

7649 Solventless Primer to two front
T-joint areas (A). At close to 5 minutes, applya3mm
(1/8 in.) bead of LOCTITE

17430 High Flex
Form-In-Place Gasket.
2. Applya3mm(1/8 in.) bead of LOCTITE

17430 High
Flex Form-In-Place Gasket to two rear T-joint areas
(C), and on inside edge of both cap screw holes for
rear oil seal housing.
3. Position new oil pan gasket on cylinder block.
4. Applya3mm(1/8 in.) bead of LOCTITE

17430 High
Flex Form-In-Place Gasket to face of oil pan gasket at
same T-joint locations (A) and (C) on cylinder block in
steps 1 and 2 above.
LOCTITE is a registered trademark of Loctite Corp.
Continued on next page
CTM100 (06APR04) 02-060-15 P OWER T ECH 10.5 L & 12.5 L Diesel Engines
040604
PN=283