PowerTech 6105HF - Clean Engine

Engine Rebuild Guide, Break-In and Tune-Up
02
010
7
RG,RG34710,48 –19–13SEP02–3/3
RG8186 –UN–05DEC97
Rear Repair Stand Cap Screws
B—Cap Screws
4. Mount engine to rear engine adapter using two
1
M16 x
2.0 x 65 mm (Class 12.9) cap screws (B). Tighten cap
screws to specification.
Specification
Engine-to-Stand Adapter Cap
Screws—Torque 400 N•m (300 lb-ft)..........................................................
1
From JDG980 Metric Bolt Kit.
RG,RG34710,49 –19–21DEC00–1/1
Clean Engine
RG8188 –UN–21MAY98
6125HRW Engine on Repair Stand
1. Cap or plug all openings (air intake, exhaust, fuel,
coolant, etc.).
2. Remove electrical components (starter, alternator,
etc.). Cover electrical components that are not
removed with plastic and tape securely to prevent
moisture damage.
3. Thoroughly steam clean engine.
IMPORTANT: Never steam clean or pour cold water
on an engine while it is still hot. To do
so may cause seizure of precision
parts.
CTM100 (06APR04) 02-010-7 P OWER T ECH 10.5 L & 12.5 L Diesel Engines
040604
PN=55