Cylinder Head and Valves
02
020
57
RG,RG34710,95 –19–27NOV00–1/2
Install Cylinder Head
RG8189 –UN–05DEC97
Installing Cylinder Head Gasket
RG8285 –UN–21MAY98
Installing Cylinder Head
A—Tab
IMPORTANT: Be sure cylinder head and block gasket
surfaces are clean, dry, and free of any
oily residue. ALWAYS thoroughly
inspect new cylinder head gasket for
possible manufacturing imperfections.
Return any gasket that does not pass
inspection.
1. Place a new head gasket on top of cylinder block. Do
not use sealant on gasket. Tab (A) on gasket goes to
left rear corner of cylinder block (as viewed from
flywheel end).
IMPORTANT: If cylinder head is lowered onto cylinder
block and you discover that the head is
not positioned correctly on locating
dowels, remove cylinder head and
install a new gasket. DO NOT try to
reposition cylinder head on the same
gasket again since the fire ring will
possibly be damaged.
2. Lower cylinder head in correct position on block using
lifting straps and a hoist. Make sure that head is
positioned correctly over dowels and that it is all the
way down on gasket.
Continued on next page
CTM100 (06APR04)
02-020-57
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=129
To Next Page
Loading...