PowerTech 6105HF - Install Flywheel

Crankshaft, Main Bearings, and Flywheel
02
040
12
RG,RG34710,160 –19–27JUL99–1/1
Install Flywheel
RG8134 –UN–21MAY98
Installing Flywheel
RG10248 –UN–30JUL99
Flywheel Tightening Sequence
CAUTION: Flywheel is heavy. Plan proper
handling procedures to avoid injuries.
NOTE: SAE 0 and SAE 2 flywheel housings must be
installed before installing flywheel. (See REMOVE
AND INSTALL FLYWHEEL HOUSING earlier in
this group.)
NOTE: ALWAYS use new cap screws when installing
flywheel.
1. Install two pilot studs in crankshaft to aid in assembly.
Position flywheel over pilot studs.
2. Install flywheel attaching cap screws. Remove pilot
studs and install remaining two cap screws.
3. Tighten flywheel attaching cap screws in the sequence
shown to the following specifications.
Specification
Flywheel-to-Crankshaft Cap
Screws—Torque 130 N•m (96 lb-ft)............................................................
4. After flywheel and housing are installed, perform
flywheel-to-housing runout checks. (See CHECK
FLYWHEEL HOUSING FACE RUNOUT earlier in this
group.)
CTM100 (06APR04) 02-040-12 P OWER T ECH 10.5 L & 12.5 L Diesel Engines
040604
PN=208