Repair Tools and Other Materials
OUO1004,0000BD0 –19–02NOV00–7/9
RG8511 –UN–20MAY98
JDG975
Front Timing Gear Cover/Rear Crankshaft Seal Housing
Centering Tool .......................JDG975
Use to center the front/rear seal housing bore with the
rear crankshaft flange during installation of the housing.
This tool is also used to center the front timing gear cover
seal housing bore with the front crankshaft flange during
installation of the timing cover. Use with JDG977.
05
170
18
OUO1004,0000BD0 –19–02NOV00–8/9
RG8512 –UN–13AUG99
JDG974A
Front/Rear Crankshaft Seal Installer ........JDG974A
Use to install the front crankshaft seal on damper prior to
damper installation and to install rear oil seal in rear seal
housing when housing is on engine.
OUO1004,0000BD0 –19–02NOV00–9/9
RG8509 –UN–13AUG99
JDG973
Damper Puller/Installer ..................JDG973
Use to safely remove and install engine damper with
engine in vehicle chassis. The damper weighs
approximately 18 kg (40 lb) and is mounted with an
interference press fit.
OUO1004,0000BD1 –19–02NOV00–1/4
Crankshaft, Main Bearings and Flywheel
(Group 040) Service Equipment and Tools
NOTE: Order tools according to information given in the
U.S. SERVICEGARD

Catalog or from the
European Microfiche Tool Catalog (MTC). Some
tools may be available from a local supplier.
SERVICEGARD is a trademark of Deere & Company
CTM100 (06APR04)
05-170-18
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=392
Continued on next page
To Next Page
Loading...
General