Lubrication System
02
060
16
RG,RG34710,219 –19–24SEP02–2/2
RG8817 –UN–20MAY98
Oil Pan Torque Sequence
NOTE: Locate rear of oil pan flush to
±
0.05 mm
(0.002 in.) with rear face of cylinder block.
5. Carefully install oil pan on cylinder block and tighten all
oil pan-to-cylinder block cap screws in sequence
shown to specifications. Start at right rear corner of oil
pan (facing toward flywheel end) and proceed
counterclockwise according to the sequence.
Specification
Oil Pan-to-Cylinder Block Cap
Screws—Torque 25 N•m (18.5 lb-ft) plus 90° Turn
Clockwise
....................................
6. Tighten oil pan-to-rear oil seal housing and oil
pan-to-timing gear cover cap screws to specification.
Specification
Oil Pan-to-Rear Oil Seal Housing
Cap Screws—Torque 25 N•m (18.5 lb-ft) plus 90° Turn
Clockwise
............................
Oil Pan-to-Timing Gear Cover
Cap Screws—Torque 25 N•m (18.5 lb-ft) plus 90° Turn
Clockwise
............................
7. Install oil pan drain plug using a new O-ring and
tighten to specifications.
Specification
Oil Pan Drain Plug 1-1/4 in. Hex
Plug—Torque 46 N•m (34 lb-ft)...................................................................
Oil Pan Drain Plug 1-1/2 in. Hex
Plug—Torque 64 N•m (47 lb-ft)...................................................................
8. If equipped, coat threads of drain hose and drain valve
with LOCTITE
592 Pipe Sealant with TEFLON
. Install
and tighten securely.
LOCTITE is a registered trademark of Loctite Corp.
TEFLON is a registered trademark of Du Pont Co.
CTM100 (06APR04)
02-060-16
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=284
To Next Page
Loading...