Cylinder Head and Valves
02
020
63
RG,RG34710,97 –19–01NOV00–4/9
RG9200A –UN–30JUL99
Torque-Turn Clamp Cap Screws
RG9202A –UN–30JUL99
Torque-Turn Clamp Cap Screws
A—Line on Socket
B—Line on Shaft Clamp
C—Line on Spacer
Torque-Turn Rocker Arm Hold-Down Clamp Cap
Screws on Engines with Dual Rail Fuel Systems
1. After applying initial torque of 30 N•m (22 lb-ft), start at
front cap screw and proceed to the rear and
torque-turn each cap screw 60°±5° as follows:
• Position a six point socket onto rocker arm shaft
clamp cap screw.
• With clockwise tension on socket (viewed from rear
of engine), mark a line (A) on socket and another
aligning mark on shaft clamp (B) [or spacers (C) at
each end location)].
Continued on next page
CTM100 (06APR04)
02-020-63
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=135
To Next Page
Loading...