Crankshaft, Main Bearings, and Flywheel
02
040
42
RG,RG34710,180 –19–13AUG99–4/4
RG8175 –UN–21MAY98
Installing Damper Retainer Cap Screws
RG10247 –UN–30JUL99
Damper Torque Sequence
RG8809 –UN–20MAY98
Front Seal Torque Sequence
7. Install large washer onto front nose of crankshaft to
secure damper to crank. Tighten cap screws in
sequence shown to specifications.
Specification
Damper Hub Cap Screws—
Torque 125 N•m (92 lb-ft)...........................................................................
8. If required, install pulley on damper and tighten cap
screws to specifications.
Specification
Pulley-to-Damper Cap Screws—
Torque 125 N•m (92 lb-ft)...........................................................................
9. Install front seal-to-timing gear cover cap screws and
tighten to specifications following sequence in lower
illustration.
Specification
Front Oil Seal Cap Screws—
Torque 15 N•m (11 lb-ft).............................................................................
CTM100 (06APR04)
02-040-42
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=238
To Next Page
Loading...