Camshaft and Timing Gear Train
02
050
15
RG,RG34710,191 –19–25OCT00–10/14
RG8822A –UN–11DEC97
Installing Supply Pump Drive Coupler
A—Fuel Supply Pump Drive Coupler
7. Install fuel supply pump drive coupler (A) onto
camshaft drive pin so that coupler is flush to 0.5 mm
(0.020 in.) above pin. Apply LOCTITE
242 Thread
Lock and Sealer to set screws.
Install set screws with the centerline of one screw
perpendicular to flat on drive pin. Tighten set screws to
specifications.
Specification
Camshaft and Supply Pump Drive
Coupler Set Screw—Torque 4 N•m (3 lb-ft)...............................................
8. Install fuel supply pump. Refer to the appropriate fuel
system repair manual.
Delphi/Lucas ECU controlled fuel systems:
• See REMOVE AND INSTALL FUEL SUPPLY PUMP
in CTM115, Section 02, Group 090.
John Deere Level 6 ECU controlled fuel systems:
• See REMOVE AND INSTALL FUEL SUPPLY PUMP
in CTM188, Section 02, Group 090 (dual rail fuel
systems).
• See REMOVE AND INSTALL FUEL SUPPLY PUMP
in CTM188, Section 02, Group 091 (single rail fuel
systems).
Specification
Fuel Supply Pump-to-Cylinder
Head—Torque 50 N•m (37 lb-ft).................................................................
LOCTITE is a registered trademark of Loctite Corp.
Continued on next page
CTM100 (06APR04)
02-050-15
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=255
To Next Page
Loading...