Air Intake and Exhaust System
02
080
20
RG,RG34710,249 –19–13AUG99–3/3
RG8132 –UN–05DEC97
Exhaust Manifold Gaskets
RG8133 –UN–05DEC97
Installing Exhaust Manifold
A—Guide Pins
B—Gaskets
C—Manifold Assembly
Install Exhaust Manifold
1. Install guide pins (A) at upper threaded hole of each
exhaust port as shown.
2. Install gaskets (B) on each guide pin as shown.
3. Install two sealing rings on both exhaust manifold end
sections and assemble with center section.
4. Install manifold assembly (C) onto guide pins.
5. Apply PT569 NEVER-SEEZ
Compound to exhaust
manifold cap screws and tighten bottom row of cap
screws finger tight. Be sure gaskets are properly
positioned before installing cap screws.
6. Remove guide pins from top row and install cap
screws finger tight.
7. Tighten all cap screws to specifications.
Specification
Exhaust Manifold-to-Head Cap
Screws—Torque 70 N•m (52 lb-ft)..............................................................
8. Install turbocharger. (See INSTALL TURBOCHARGER
earlier in this group.)
NEVER-SEEZ is a registered trademark of the Emhart Chemical Group.
CTM100 (06APR04)
02-080-20
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=320
To Next Page
Loading...