Repair and General OEM Specifications
06
200
15
OUO1004,0000BD3 –19–19SEP02–2/3
Item Measurement Specification
Crankshaft Main Bearing Journal OD 124.983—125.017 mm (4.9206—
4.9219 in.)
Crankshaft Main Journal Max. Out-of-Round 0.025 mm (0.0010 in.)
Max. Taper per 25.4 mm (1.0 in.) of 0.0025 mm (0.0001 in.)
Journal Length
Main Bearing Cap Bore ID Without Bearings 133.097—133.123 mm (5.2400—
Specifications 5.2411 in.)
Max. Bore Diameter Variation 0.013 mm (0.0005 in.)
Max. Bore Diameter Taper 0.005 mm (0.0002 in.)
Max. Straightness (Any 0.038 mm (0.0015 in.)
Bore-to-Adjacent Bore)
Max. Straightness (5 Center 0.076 mm (0.0030 in.)
Bores-to-Adjacent Bore)
Centerline of Bore-to-Top Deck 429.92—430.07 mm (16.926—
16.932 in.)
Crankshaft Main Bearing Cap Surface Width 39.75—40.25 mm (1.565—1.585 in.)
Crankshaft Main Bearings Available Undersize 0.25, 0.50 mm (0.010, 0.020 in.)
Oversize Thrust Washers Available Thickness 0.18 mm (0.007 in.)
Thrust Bearing New Part Thrust Washer Clearance Base 162.24—163.76 mm (6.387—6.447
Specifications Circle in.)
Thrust Surface Width 42.05—42.12 mm (1.656—1.658 in.)
Relief Angle 45°
Bearing Cap Overall Width 43.46 mm (1.711 in.)
Thrust Surface Maximum Runout 0.025 mm (0.0010 in.)
Crankshaft Main Bearing Cap Initial Torque 68 N•m (50 lb-ft)
Screws
Crankshaft Main Bearing Cap Final Torque 320 N•m (236 lb-ft)
Screws
Rear Oil Seal Housing Cap Screws Torque 25 N•m (18 lb-ft)
Rear Oil Seal-to-Housing Cap Torque 15 N•m (11 lb-ft)
Screws
CTM100 (06APR04)
06-200-15
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=425
Continued on next page
To Next Page
Loading...