© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 134
6 The belt guard assembly is two interlocking halves and needs to be separated before it can be removed
from flat belt:
a) Lower the belt guard down just below the upper arm.
b) Squeeze the belt guard near the base to release locking tabs and rotate the two halves down.
c) Taking care to not lose the rollers inside the belt guard, pull the two belt guard halves away from
each other to separate.
FIGURE 105: BELT GUARD REMOVAL
Upper Arm Flat Belt Pulley Removal
7 Remove the mounting bolts, the two washers and the nut that secure the upper arm pulleys to the upper
arms.
FIGURE 106: UPPER ARM FLAT BELT PULLEY MOUNTING
To Next Page
Loading...
Need help?
General
