© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 249
a If less than ¼ inch, set the Cross Ramp to level 1 and readjust the lift motor actuator tube to increase
the mounting distance. Remove the lift motor mounting pin, rotate the lift motor actuator tube ½ turn
“counterclockwise”, manually raise the lift platform to align the mounting holes and reinstall the hitch
pin. Verify that the incline level 5 A/D value is within specification, Readjust if necessary.
b If greater than 3/4 inch, set Cross Ramp to level 1, and readjust the lift motor actuator tube to
decrease the mounting distance. Remove the lift motor mounting pin, rotate the lift motor actuator
tube ½ turn “clockwise”, manually raise the lift platform to align the mounting holes and reinstall the
hitch pin. Verify that the incline level 5 A/D value is within specification, Readjust if necessary.
26 Set the Cross Ramp to level 1. Verify the A/D value is between 38 and 42.
27 Operate the incline through its entire range to ensure proper operation.
28 Reinstall the front, side, and rear covers.
29 Verify the AMT operatio
To Next Page
Loading...
Need help?
General
