Section 18: BODY
PA1562
17
and install the front bumper. Safely support the
bumper and remove the two bolts on each
bumper side to separate the bumper from the
spare wheel compartment door. To install
bumper, reverse the removal procedure.
WARNING
Front bumper is heavy. Use proper lifting
equipment to support the bumper during the
removal and installation operations to avoid
personal injury.
FIGURE 9: FRONT BUMPER RELEASE HANDLE 18613
FIGURE 10: FRONT BUMPER
18614
FIGURE 11: FRONT BUMPER REMOVAL 18565
7.2 FRONT CREST
• Use a Chix cloth and anti-silicone to clean
the surface where the crest will be applied.
CAUTION
Do not exceed the crest dedicated surface.
• Peel the back from the self adhesive crest
side pieces.
• Peel the back from the self adhesive crest
center piece. Center crest and apply.
• Compress the crest three pieces using your
hands.
7.3 HEADLIGHTS
Refer to Paragraph 9.1 Headlights, included in
Section 06: Electrical of the Maintenance
Manual for complete information on headlights.
To Next Page
Loading...
