Section 18: BODY
PA1562
26
• Apply Sika 255 at junction of frame and
window.
• Install and center window onto door frame.
Using your hands, compress window.
• Discard waste according to applicable
environmental regulations, use dangerous
waste containers.
• Apply masking tape before applying Sika
glue to protect paint and adjacent surfaces
during surface treatment
Body Panel
For the removal of entrance door body panel,
you will need:
Pneumatic “Zip gun” type tool;
Razor sharp window scraper;
• Open entrance door.
• Remove interior finishing panels to access
rub rail fixing bolts, then remove rub rail.
• Remove door lock and interior lighting.
• Using the “Zip Gun”, cut Sika bead located
¼ inch (7-8 mm) from each body panel
edge.
NOTE
Wear ear plugs during this operation.
• Separate body panel from door.
• Using a razor sharp window scraper,
remove from door frame Sika bead and
double-face self adhesive tape residue.
• Using a scratch pad “Scotch Brite”, scratch
the perimeter of the door frame where the
adhesive will be applied.
• Clean door frame again using anti-silicone.
• Apply some Sika 206 G+P onto door frame.
• Using a scratch pad “Scotch Brite”, scratch
the perimeter of the body panel where the
adhesive will be applied.
• Clean body panel using anti-silicone.
• Apply some Sika 206 G+P onto body panel.
• Apply 1/8 x1/4 double face self-adhesive
tape onto door frame.
NOTE
Leave some space at the bottom (50mm) for
water dripping.
To Next Page
Loading...
