Section 18: BODY
PA1562
27
• Apply Sika 255 onto door frame structure.
Note: Leave some
space at the bottom
(50mm) for water
dripping.
• Install and center fiber glass body panel
onto door frame leaving an excess of 3mm
all around the frame.
• Line-up body panel with window. There
must be a gap of 4±2mm between window
and body panel.
• Apply some masking tape 1mm from
window edge and body panel.
• Fill the gap between window and body panel
with Sika 255.
• Smooth down the joint with a plastic scraper
then remove masking tape.
• Wet Sika joint using water to accelerate the
curing process and put the finishing touch
with your finger.
• Discard waste according to applicable
environmental regulations, use dangerous
waste containers.
To Next Page
Loading...
