Section 18: BODY
PA1562
33
• From vehicle’s interior, apply some Sika 255
and make 2 finishing joints. Smooth down
the joints and remove masking tape.
• Reinstall clearance lights.
• Discard waste according to applicable
environmental regulations, use dangerous
waste containers.
Glued Molding Installation
• Clean window gluing area using window
cleaner.
• Apply Sika Aktivator onto gluing area
making sure to avoid Sika adhesive if it is
not cured yet.
Apply anti-silicone onto molding.
• Apply Sika 205.
• Clean gutter using anti-silicone.
• To seal screw holes, remove screw, apply
Sika 205 inside the hole then apply Sika
252.
• Apply a double-face self adhesive tape 1/8
by ¼ inch inside the molding onto the whole
length.
• Apply a double-face self adhesive tape 1/32
by ¼ inch onto the whole length of the
gutter.
• Apply Sika 252 inside the moldings onto the
whole length.
To Next Page
Loading...
