Section 18: BODY
PA1562
34
• Position and fix vertical molding. Lean
vertical molding against lateral molding.
Make sure vertical molding lines up with
structural tubing.
SECTION VIEW A-A
• Position and fix horizontal molding (gutter).
Lean gutter against vertical molding.
Position gutter just above Sika finishing
joint.
• Apply masking tape on each side of vertical
molding. Apply Sika 252 to fill the gap
between molding and windows.
• Smooth down the joint with finger.
• If required, clean surfaces using Sika 208.
7.7.10 Front Cap
The fiberglass front cap does not need any
maintenance except painting as needed. It is
held in place with adhesive. If ever it has to be
replaced, make an appointment at a Prévost
service center near you. For minor damages,
refer to section 4 "Fiberglass Repair" and
section 5 "Painting".
To Next Page
Loading...
